during cutting of reeds

The convex rod is formed in a smooth uniform curve which results in approximately 5 degrees of angle change from the beginning of each stroke to the end

1 mm Minimum diamond layer thickness 2 mm Real diamond layer thickness 2-3 mm Durable CNC milled duralumin base plate Diamond layer is glued to the base plate Marking is clearly visible on CNC milled aluminum No copper in the binder

Helps with sharpening long knives

Gritomatic Silicon Carbide Stones are recommended to be used with water as a lubricant

low profile clamp for kme during cutting of reedsThe difficult problem of sharpening small blades has been solved with these smaller clamps for KME knife sharpeners. Replace the traditional clamps on any KME sharpener with these jaws. These clamps are perfect for small knives and those with a more narrow structure. Most small blades can be sharpened at 17 degree angles and some blades lower than that.