Attach the rear LED using the original screws and route the cables through the shock tower

to protect them and prevent them from coming into contact with sharp edges

Entfernen Sie die beiden M4-Schrauben

Attention: The LEDs from the Wald Light Kit can only be operated with the Power Up module

the light is simply secured with 4 screws and connected directly to the receiver

Triple Spike DBXL 2.0 / DBXL-E 2.0 Attach the rear LED usingExtremely bright rear LED, which is easily attached to the rear spoiler bracket. To install, simply clamp the light and connect it to the existing front LED connector. The installation is very straightforward and can be done without much effort. Installation Instructions Loosen the four screws on the spoiler bracket. Clamp the LED between the struts of the spoiler bracket and lightly tighten the screws again. Ensure that the LED is securely in place